General information
OpenPlant Modeler Training - Advanced
| Duration | 3 days (21 h) |
| Mode | Present or distancial |
| Level | Experienced |
| Basis required | Knowledge of MicroStation 3D and OpenPlant Modeler |
| Maximum number | 6 persons |
OpenPlant Modeler is a modular design solution in engineering. This training teaches the modeling of a numerical model until the creation of deverbal documents. This training offers the installation of equipment, piping lines, support. Component placement methods and their modifications. The exploitation of the model to end with the generation of plans, generation of disometrics, report completes the formation.
beCAD srl is the only official Francophone centre in the program Bentley Training Partner. This will guarantee you quality training that will enable your teams to effectively master the software used.
Training programme
The points to be discussed during this training will be based on the creation of a digital model and will be as follows:
1. Equipment
- The functions of the Equipment menu.
- Graphic placement
- Modification Graphic manipulation of elements
- Editing element data
- Creation of undefined elements
2. Tube
- The functions of the Pipe menu.
- Box Manager Management
- Concept of piping classes
- Graphic placement
- Modification Graphic manipulation of elements
- Graphic reconnection of elements
- Editing element data
- Creation of undefined elements
- Connection between piping components
3. Tubing support
- Support menu functions
- Box Manager Management
- Concept of support classes
- Graphic placement
- Modification Graphic manipulation of elements
- Editing element data
- Creation of undefined support elements with or without class of
Pipe support
4. Hvac (Ventilation)
- The functions of the Hvac menu.
- Box Manager Management
- Concept of Hvac classes
- Graphic placement
- Modification Graphic manipulation of elements
- Editing element data
- Creation of undefined Hvac elements with or without Hvac class
5. Raceway
- The functions of the Raceway menu.
- Box Manager Management
- Raceway class concept
- Graphic placement
- Modification Graphic manipulation of elements
- Editing element data
- Creating Raceway elements not defined with or without Raceway class
6. Structure
- Structure menu functions
- Box Manager
- Selection of structural elements
- Graphic placement
- Modification Graphic manipulation of elements
- Editing element data
- Concept of massive, slab, wall
7. Extraction of the model
- 2D layout
- Smart Annotation
- Ratings
- Dressings
- Generation of reports
- Export extraction
- Imports
